Topwater Caranx Ignobilis: Giant Trevally (GT) > Tackle & Techniques

Saltiga radiation knob

<< < (2/2)

Les Maunder:
Hi Chris

The standard knob is mostly made of hard plastic including the pressure surface that touches with the friction washers

The Radiation knob is all aluminium.

The SOM is mostly aluminium with the pressure surface area made of a some type of rubber (high temp I presume).

Yes, the SOM is my pick as drag pressure increases in a much more progressive manner than the Radiation. ( I can't remember which site, but this subject of the Radiation has been discussed previously). Note that Plat.co.jp are discontinuing to stock them.



Good luck


Les

 

 

Brandon Khoo:
you should check your drag stack to make sure it has been fitted properly


--- Quote from: Les Maunder on June 26, 2011, 09:18:54 PM ---This might upset the apple cart, but I have tried and tested the Radiation knob and found it to be difficult to adjust in the final stages of drag pressure - i.e. the last half turn of the drag knob significantly increases the drag pressure (from zero to hero).

The SOM Drag Knob is more parabolic in application and easier to work with.

Also note I have seen a standard Daiwa drag knob melt under extreme pressure.


Cheers


Les



 

--- End quote ---

Navigation

[0] Message Index

[*] Previous page