Topwater Caranx Ignobilis: Giant Trevally (GT) > Tackle & Techniques

The MC Works aftermarket handles - maintenance issues

<< < (7/7)

neville hood:
Dante
Try low heat like those heat guns. Sometimes I would expect that blue threadlocker might be used to ensure to be sure the knobs wont came loose. Failing that, drill the screw out slowly and use a very small easy-out. Due to the heat of the drill going round helps the easy-out to work better. You may sustain a little damage to the top of the thread but all you do is countersink the hole a little or run a tap /die through it. When you get a new screw for the knob if you are going to pull it apart regulary put some 'never seize' on the thread to make fror easier removal. Hope I havent stated the obvious so have fun.  :)

dante green:
Thanks fellas!! ;)

Just wanted give the heads up that saltywatertackle carries ceramic bearings for the MC Works handle.


cheers

D.

Michael Sammut:
yea i just stumbled across the ceramic bearings today and ordered some.  hopefully should be good!

Navigation

[0] Message Index

[*] Previous page