Topwater Caranx Ignobilis: Giant Trevally (GT) > Tackle & Techniques

razor-gang proof bite leaders

<< < (3/3)

Mark Harris:
For a bite leader section including quite a bit for knotting, about 80 cm I reckon.

Looking at it I also think the large size required to sleeve over a 200 lb leader might cost more than $40 for 5 metres.

Ricky Lim:
Common people!!!!

$40 extra to save a few gammas. Is worth it dont you think?

Ben Furness:
I have heard that you can use a heat shrink over the Zylon if you slip it over the first eye of a swivel. Would that be enough to hold it in place?

Dmitrii Novgorodtcev:
Brandon,

YGK has special scissors for kevlar. It cuts zylon well.
And Nakazima's big size scissors cut zylon perfectly and cost nothing.

Kiel Hinds:
A couple other options for bite leader might be the Owner power flex which has a wire core and is more so used for assist chords
but you could try it for popping as well. And another product that is relatively new is Tuf line tufleader. Like i said though, it's relatively new
so I don't know too much about it. Here's the youtube link I found about it. Might be worth a shot.

Stainless Steel Leader in the Surf

Navigation

[0] Message Index

[*] Previous page