JM Power Knob 45 problems

[wes_jones]

Gday guys


Merry Christmas and all the best for 2013 to start of with.

For Christmas i recieved 2 Jigging Master Power Knob 45's, but in trying to fit them i have come to a bit of a dead end. my problem is that i cannot fit the knob over the bottem bearing on the handle shaft. just wondering if anyone has had any experiance with these knobs and could tell me what im doing wrong. the knob intructions say they will fit a 6000sw to a 20000sw and I'm trying to fit them to a 10000sw and a 18000 sw so im guessing i have been given the right size knob.

do i need a different bearing or shaft??

any help would be much appreciated

Cheers Wes

[Nicolas Lim]

You should have been given some bearings to go along with it. The bearings from JM would be slightly smaller in order for you to fit the power knob over them on the standard Shimano shaft.

[wes_jones]

sorted cheers mate

the two knobs i recieved where missing both there specific bearings for the job so i had to source them after

Cheers Wes