Topwater Caranx Ignobilis: Giant Trevally (GT) > Tackle & Techniques

Stella 13 SW18000 and aftermarket spools

(1/2) > >>

Mark Harris:
Has anyone has problems fitting 20000 spools on the new Stella 18000?

Very annoyingly my SOM 20000 is tiny bit too big for the new Stella 18000. When cranking there is a little noise as the base of the spool just touches the base of the rotor.  This did not happen with the 08 Stella 18000.

The 08 standard 20000 spool does not do this and seems to fit the new18000 just fine. Has anyone tried the Yumeya Max 20000 spool with the new 18000?  I was wondering if this problem was with SOM spools only.

Clem Henry:
Mark, you may be able to add a spacer to lift the spool without it negatively effecting the line lay.. Will depend on the amount of adjustment that the spool will allow? would need to check to confirm...

Christoffer Hansen:
Maybe it's a sign to stick with the spool that's on the reel to start with!
Putting a som spool on your downgrading!

Mark Harris:
That's a good idea Clem and I will try one spacer and see if it makes enough difference to create the required clearance. It might as the touching is very minor.  Thanks very much for this pointer.

Mark Harris:
Just a  follow up on this, one spacer did the trick - thanks Clem!

The same problem exists with the SOM 6000 and new Stella 5000 - the spool just clips the base of the rotor. Again, one spacer stops this.

Makes me a touch nervous about what might happen under load. I think some caution is required with using SOM spools designed for Stella 08s with the Stella 13s.

Navigation

[0] Message Index

[#] Next page