0 Members and 3 Guests are viewing this topic.

Jussi Saarinen

  • Fusilier
  • *
  • 30
  • Liked:
  • Likes Given: 0
Stella 18000 bent engine/rotor arm
March 17, 2014, 09:19:27 AM
When inspecting my 2008 Stella 18000, following my recent trip to Southern Oman, I realized to my big surprise that the five GTs I had landed had bent the "engine", where the rotor arm is attached. Has anyone had this happened to you before? Also, is it repairable or do I have to buy a new reel?

/Jussi




Alex Jordan

  • Bluefin Tuna
  • ***
  • 356
  • Liked:
  • Likes Given: 0
Re: Stella 18000 bent engine/rotor arm
March 17, 2014, 09:52:10 AM
Not seen that before! - if its just the wire part it's cheap to replace from Shimano with the non roller arm included in the part :)

Trevor Skinner

  • Bluefin Tuna
  • ***
  • 455
  • Liked:
  • Likes Given: 0
Re: Stella 18000 bent engine/rotor arm
March 17, 2014, 02:09:30 PM
Jussi,

I've seen it before. As I've said don't use those spools.

Send it to Shimano, Stellas are fixable regardless.

Regards,


Trevor

Peter Olesen

  • Red Bass
  • **
  • 151
  • Liked:
  • Likes Given: 0
Re: Stella 18000 bent engine/rotor arm
March 17, 2014, 04:19:48 PM
Jussi, mine looked the same on an 8000 SW-A. I unmounted the rotor and put it back in place end then everything looked fine again! The rotor had just slipped a bit. Could be the same with yours.
Last Edit: March 17, 2014, 07:03:06 PM by Peter Olesen
"If I had more time, I would have written a shorter letter." Mark Twain

Jussi Saarinen

  • Fusilier
  • *
  • 30
  • Liked:
  • Likes Given: 0
Re: Stella 18000 bent engine/rotor arm
March 17, 2014, 05:00:33 PM
Thx!