0 Members and 2 Guests are viewing this topic.

Alex Gomez

  • Fusilier
  • *
  • 134
  • Liked:
  • Likes Given: 1
Refurbing carpenter rods
March 27, 2015, 09:07:54 PM
Anyone know if it is possible to refurbish Carpenter rods?

I purchased an old custom LGM X-83 but it has some cracks on the whipping and I'd like to get the guides re done.

It's a very old rod and was apparently from the time when Carpenter rods were hand made!

Is there anyone in Sydney area that offers this service?

Cheers!!

AG

Felix Lux

  • Fusilier
  • *
  • 118
  • Liked:
  • Likes Given: 0
Re: Refurbing carpenter rods
March 28, 2015, 05:24:53 AM
No problem as long as the blank is undamaged. Any good rod builder will be able to do it.
Look up Killer Curves Custom Rods on FB, John does very nice clean work.

Luke Wyrsta

  • Administrator
  • Giant Trevally
  • ********
  • GTPopping.com Founder
  • 3293
  • GT Monster
  • Liked:
  • Likes Given: 0
Re: Refurbing carpenter rods
March 28, 2015, 12:57:57 PM
Anyone know if it is possible to refurbish Carpenter rods?

I purchased an old custom LGM X-83 but it has some cracks on the whipping and I'd like to get the guides re done.

It's a very old rod and was apparently from the time when Carpenter rods were hand made!

Is there anyone in Sydney area that offers this service?

Cheers!!

AG

A most any rod can be refurbished and or built again... You just need to find the right rod builder.

Carpenter is no different.

Alex Gomez

  • Fusilier
  • *
  • 134
  • Liked:
  • Likes Given: 1
Re: Refurbing carpenter rods
March 29, 2015, 07:12:30 PM
Excellent, thanks a million gents

AG

Zubin Balen

  • Phytoplankton
  • *
  • 1
  • Liked:
  • Likes Given: 0
Re: Refurbing carpenter rods
April 07, 2015, 05:54:05 PM
if your looking for an excellent rod builder go to Tom 0413 471 230 works at fish out of water also known as Tbc RodCo .. he knows his stuff and his work is awesome tell him zubin sent ya best of luck mate

https://www.facebook.com/tbc.rodco/about