Having issues with this. Ordered the handle and said what reel it was for. Took off the old rubber knob no dramas, removed the two bearings, at the foot of the internal shaft and from the inside of the rubber knob, slid the lower bearing back on the shaft with it's two washers, dropped the JM shaft over the internal shaft, then dropped in the top bearing and finished with the small nut.
It looks like I'm missing a part as the JM shaft is not held firmly on the internal shaft, it can slide up and down. It looks like either I have the wrong shaft, or I'm missing a spacer part, or I'm doing it all wrong.
It was the type D adapter that I was sent if that's any help?
Appreciate any advice or help!
