Topwater Caranx Ignobilis: Giant Trevally (GT) > Tackle & Techniques

FG and PR Knots

<< < (7/8) > >>

Peter Childs:
Gavin, see my post above, the further down the knot you get away from the hitch end, the less it will bite (as you tension it) - you'll eventually get to the point when further wraps simply will not tension at all.  If about 2/3 are visibly biting that would sound about right to me, I'm finding about 12 - 15 turns does the trick too.

Gareth Branicki:
Mark love info on the bouz lighter  nomad stocks them hate burning my finger tips with the lighter .
Peter with the 80 lb i using about 18 wraps length which ends up  jsut with wraps about nearly 2 cm  have really tightend the wraps last one felt as if i had used my pr bobbin  your mentioned the knot requires some slippage  am i tying the wraps to tight
cheers

Mark Harris:
As well as avoiding burning your fingers Gareth, the Bouz cutter is windproof and most importantly makes sure that the heat does not get too close to the business areas of the knot.

Peter Childs:
Gareth, the amount of slipping is minute (its probably 0.5 mm or so), you will know the knot has bitten as the braid changes colour ever so slightly (closest to the hitches) as the heat from the slipping braid fuses it onto the mono - look real close!  If you are using yellow braid it will go slightly darker.

Jon Li:

--- Quote from: Peter Childs on December 08, 2010, 03:48:40 PM ---Gareth, the amount of slipping is minute (its probably 0.5 mm or so), you will know the knot has bitten as the braid changes colour ever so slightly (closest to the hitches) as the heat from the slipping braid fuses it onto the mono - look real close!  If you are using yellow braid it will go slightly darker.

--- End quote ---

Hi Peter ,

Good observation , it pays to lubricate the knot as it is being pulled on both ends , I use water to help dissipate the heat when doing MidKnot .

Jon .

Navigation

[0] Message Index

[#] Next page

[*] Previous page